CASARIA 109657 Instrucciones De Montaje página 6

GENERAL SAFETY INFORMATION FOR USE
WARNING!
The product must not be installed without adequate fixing to the wall.
•
• When mounting, check the selected attachment point for hidden supply lines (water, electricity,
gas) before drilling.
• Wear suitable protective equipment (safety goggles, ear defenders, clothing) during
installation.
• The product requires a USBA/5V power adapter (not included).
• Be sure to disconnect the power supply before dismantling / reassembling or adjusting the
product.
• To avoid danger, if the device is damaged, contact our Customer Service team or send the
device to one of our authorised service centres for replacement, and do not attempt to replace
it without our authorisation.
INTENDED USE
The bedside table is intended for the storage of lightweight itemsand is designed for indoor use
only. Only use the product for its intended purpose. The manufacturer accepts no liability for
damage caused by improper use. Any modification to the product may negatively impact safety,
cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product. After unpacking, please check the product for damage
and to ensure it is complete. Subsequent complaints cannot be accepted.
FIRST USE AND USE OF THE LIGHT
1. Connect to a power supply.
2. Briefly touch the on/off sensor to switch the light on. The light will now shine in warm white
mode.
3. Briefly touch the on/off sensor again to switch from warm white to cool white mode.
4. To increase or decrease the light's brightness in each mode, touch and hold the on/off sensor.
5. Touch the on/off sensor again to turn off the light.
MAINTENANCE AND CARE INSTRUCTIONS
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Only have parts replaced with genuine spare parts by a specialist in accordance with the
manufacturer's specifications. A lack of care and maintenance can damage the appliance.
Dangerous situations can arise. To ensure electrical safety, the appliance must not be subjected
to liquids or be immersed in them. Regular maintenance helps to ensure the safety of the product
and increases its service life.
Note: The LEDS cannot be replaced. The whole product must be replaced when the LEDs reach
the end of their service life.
6 www.DEUBAXXL.de