Briggs & Stratton Snapper SST-18CL Manual Del Propietário página 5

TOOL LIST
Screwdriver (Phillips or Standard)
Allen wrench 4mm
x
=
INSTALLING CUTTING HEAD
Lock gear box by inserting a pin thru hole and finding
corresponding notch.
To install head, turn counterclockwise. Hand-tighten head
securely.
To remove head, turn clockwise.
INSTALL ASSIST HANDLE
Use the 3 screws provided for this assembly. Mount the
back edge of the handle clamp to match the arrow on the
tube. Adjust the handle for comfort and good balance.
Check that the cutting line of the unit is away from your feet
and legs. i
On>+H
INSTALLING DEBRIS GUARD
The top clamp is fixed to the tube in the proper position.
Attach the debris shield to the clamp with the two screws
and hardware provided. Tighten the attaching screws firmly.
STOP AND START SWITCH
Ignition switch
Stop
Start
SHOULDER HARNESS
Place the strap over your left shoulder and attach clip to
clamp eye on shaft tube.
Loosen clamp screw and slide clamp up or down until unit
balances with head just touching the ground.
Tighten screw.