Troy-Bilt 020210 Manual Del Propietário página 10

Section 4: Opecat[on
I-tow to Use the SprayT[ps
The quick-connect on the nozzHe extension aHHowsyou to
switch between five different spray tips.The spray tips vary
the spray pattern as shown bellow (Figure 9).
CAUTION
* NEVER exchange spr D, tips without locking the safety latch
on the trigger:
FoJJow these instructions to change spray tips:
H. Engage safety Hatch on spray gun.
2. PuHH bacH< coHHar o n qock-connect and puHH current
spray tip off. Store spray tips in space provided on
handle storage pane[.
3. SeHect desired spray tip:
For gentle rinse, seHect white 40 ° or green 25 °
spray tip.
To scour surface_ select yellow [5 ° or red 0° spray
tip.
To appHy chemical seHect bHack spray tip.
4. PuHH bacH<on collar, insert new spray tip and reHease
coHHar.Tugon spray tip to make sure it is secureHy in
pHace.
5. For most effective cHeaning, keep spray tip from 8 to 24
inches away from cHeaning surface, if you get spray tip
too chose, you may damage cHeaning surface. DO NOT
get c[oser than 6 inches when cHeaning tires.
1
and Chemical
iMPORTANT: Use soaps designed specifically for
pressure washers. HousehoHd detergents couHd damage
the pump.
• Starting the engine without
aJl the hoses
connected and
without the water turned ON will damage the pump_
Damage to equipment resuking from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
H. Review spray tip use.
2. Prepare detergent soHution as required by manufacturer.
3. PHace chemica[ injection siphon/tiNter into detergent
container.
• When inserting the filter" into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler:
4. Make sure bHack spray tip is instaHHed.
NOTE: Detergent cannot be appHied with the high
pressure spray tips (White, GreemYeHHow, or Red).
Low Pressure
Use to appHy
chemicaH
BHack
White
40 °
i i
Green Yellow
25 ° HS °
i i
Red
0 o