Troy-Bilt 020210 Manual Del Propietário página 12

GENERAL MAmNTENANCE
RECOMMENDATmON$
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
° Some adjustments will need to be made periodically to
properly maintain your pressure washer.
° All maintenance in this manual and the engine owner's
manual should be made at least once each season.
° If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi.
Before
i. Check
2. Check
3. Check
4. Check
5. Check
6. Check
leaks.
Each
Use
engine oil HeveL
water inlet screen for damage.
incline filter for damage.
high pressure hose for leaks.
detergent siphoning tube and filter for damage.
spray gun, nozzle extension, and spray tips for
7. Rinse out garden hose to flush out debris.
PRE$SU
RE WASH
ER
MAINTENANCE
Check
and Clean Inlet
Screen
Examine the screen on the water inlet. Clean it if the
screen is dogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Replacement hose rating NUST exceed maximum pressure
rating of unit.
Check Deter_honin_Tube
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Cleaning Detergent $iphoningTube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
I. Place chemical injection siphon/fiker in a bucket full of
clean water.
2. Attach bhck low pressure spray tip.
3. Flush for 1=2 minutes.
4. Shut off engine.
mMPORTANT:
Simply shutting OFF engine wiii not
release pressure in the system. When the engine has
shut down, squeeze the trigger on the spray gun to
relieve the pressure [n the hose.
Check
Gun
and
Nozzle Extension
Examine the hose connection to the spraygun and make
sure it is secure.Test the trigger by pressing it and making
sure it springs back into place when you release it. Put the
safety latch in the on position and test the trigger.You
should not be able to pressthe trigger.
Check In-Line Filter
Refer to Figure 10 and service the in=line filter if it
becomes clogged, as follows:
Nozzle Extension
Filter Screen
O=ring