Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Always stop engine, disconnect spark plug wire, and ground against
engine before performing any type of maintenance on your machine.
GENERAL RECOMMENDATIONS
•
Always observe safety rules when performing any maintenance.
•
The warranty on this lawn mower does not cover items that have
been subjected to operator abuse or negligence. To receive full
value from warranty, operator must maintain the equipment as
instructed here.
•
Changing of engine-governed speed will void engine warranty.
•
All adjustments should be checked at least once each season.
•
Periodically check all fasteners and make sure these are tight.
ENGINE MAINTENANCE
Spark Plug
For good performance, the spark plug must be properly gapped and
free of deposits. Replace the spark plug annually.
1.
Disconnect the cap from the spark plug, and remove any dirt from
the spark plug area.
2.
Use the proper size spark plug wrench to remove the spark plug.
NOTE: Replace with a Champion® RJ2YXLE spark plug.
3.
Check the gap with a wire gauge. See Figure 15. Spark plug gap
should be 0.020 in (0.51 mm). If necessary, reset the gap.
4.
Install and tighten the spark plug to the recommended torque (180
lb-in [20 Nm]).
5.
Attach the spark plug cap to the spark plug.
Air Cleaner
A dirty air cleaner will restrict air flow to the carburetor and cause poor
engine performance. Inspect the filter each time the engine is oper-
ated. You will need to clean the filter more frequently if you operate the
engine in very dusty areas.
Clean the air cleaner every 25 hours of operation or once a season.
Replace the air cleaner annually.
WARNING
Never start or run the engine with the air cleaner assembly or the air
filter removed.
NOTE: Do not use pressurized air or solvents to clean the filter. Pres-
surized air can damage the filter and solvents will dissolve the filter.
1.
Loosen the fastener that holds the cover and tilt plastic housing
cover on side of engine down. See Figure 16.
2.
Remove air filter from plastic housing cover.
3.
To loosen debris, gently tap the filter on a hard surface. If the filter
is excessively dirty, replace with a new filter.
4.
Insert cover's tabs into slots in bottom of base.
5.
Tilt cover up into place and secure with fastener.
SERVICE AND MAINTENANCE
Electrode
0.020 in. (.51mm)
15
Figure 15
Figure 16
Publicidad
