Xylem Jabsco 37045 Serie Manual De Instrucciones página 5

shaft. Tighten the chopper while holding the motor shaft at the rear of the motor. Position a new O-ring in the seal housing O-ring groove (it
may be retained in the groove with a small amount of grease).
Slide the pump assembly into the toilet base ensuring the macerator housing is properly positioned within the base. The cut-out in the side
of the macerator housing must align with the discharge port in the base (the macerator housing is keyed so it will only go in when properly
positioned). Ensuring the O-ring is still properly positioned in the O-ring groove in the seal housing, place the pump assembly against the
base and secure it in place with the four screws and lock washers. Replace the white motor cover by snapping it down over the pump motor.
If toilet is plumbed to an overboard discharge, close the discharge seacock prior to disassembling toilet.
EXPLODED VIEW
VUE ÉCLATÉE / EXPLODIERTE ANSICHT / VISTA ESPLOSA / UITGEBREIDE WEERGAVE / SPRÄNGVY / VISTA EXPLOTADA
Key Description
1 Seat & Cover
Note - 2016 models identified with Jabsco logo on top of bowl.
Compact
Regular (Pre 2018)
Regular (2018 onwards)
Soft Close (2018 onwards)
2 Bowl
Compact
Regular
3 Hinge Set (1 PAIR)
Compact (ALL VARIANT)
Regular (Pre 2018)
Regular (2018 onwards)
Soft Close (2018 onwards)
3 & 4 Bowl Spud & Intake Elbow &
O-ring
5 Hose, 6 feet
7 Bowl Installation Hardware
7A Nut Cap**
7B Hex Nut** (Two places)
7C Washer, Stainless Steel**
7D Washer, Plastic**
7E Washer, Starlock**
7F Phillips Head Screw**
8 Bowl O-Ring Seal
9 Base Assembly**
10 1-1/2" Adapter, Discharge Port
11 Joker Valve* **
12 1" Discharge Port**
WARNING: FLOOD HAZARD
Failure to do so can result in flooding which can cause loss of property and life.
Qty. Part Number
1 29097-1000
1 29127-1000
1 58104-1000
1 58104-2000
1 29096-0000
1 29126-0000
1 29098-1000
1 29098-2000
1 58105-1000
1 58105-2000
1 58107-1000
1 29035-1031
1 18753-0637
4
8
4
4
4
4
1 44101-1000
1 37004-1000
1 98023-0080
1 44106-1000
1 44107-1000
Key Description
13 Screw**
14 Chopper Plate with Lock Nut †
15 Macerator Housing †
16 Centrifugal Impeller †
17 Set Screw †
18 O-ring* †
19 Seal* †
20 Screw †
21 Washer, Plastic* †
22 Seal Housing †
23 Lock Washer #10, Stainless Steel †
24 Screw †
25 Slinger †
26 Motors:
Motor - 12 Volt †
Motor - 24 Volt †
27 Solenoid Valve:
12 Volt
24 Volt
28 Switch Panel
29 Screw Covers (3/kit)
Service Kit
Motor & Pump Assembly
12 Volt
24 Volt
5
Qty. Part Number
3 96050-0568
1 37056-1000
1 37014-0000
1 37006-0000
1
1 43990-0066
1 1040-0000
2
2 35445-0000
1 37043-1000
4
4 91027-0011
1 6342-0000
1 18753-0554
1 18753-0555
1 37038-2012
1 37038-2024
1 37047-2000
1
90197-0000
1 37072-0092
1 37072-0094
* Parts Supplied with Service Kit
** Parts included with base 37004-1000
† Parts included in Motor & Pump Assembly