Craftsman 139.53901DM1/2 HP Manual Del Propietário página 8

ASSEMBLY STEP 1
Assemble the Rail & Install the Trolley
To avoid installation difficulties, do not run the garage door
opener until instructedto do so.
The front rail has a cut out "window" at the door end (see
illustration). The hole above this windowis larger on the top of
the raft than on the bottom. A smaller hole 3-1/2" (8.9 cm) away
is close to the rail edge. Rotate the back rail so it has a similar
hole close to the oppositeedge, about 4-3/4" (12 cm) from the
far end.
1. Removethe straight door arm and hanging bracket packaged
inside the front rail and set aside for Installation Step 5 and 12.
NOTE: To prevent INJURY while unpacking the rail carefully
remove the straight door arm stored within the rail section.
2. Align the rail sections on a flat surface as shown and slide the
tapered ends into the larger ones. Tabs along the side will lock
into place.
To prevent INJURY from pinching, keep hands and fingers
away from the joints while assembling the rail.
3. Placethe motor unit on packing material to protect the cover,
and rest the back end of the rail on top. For convenience, put a
support under the front end of the rail.
4. As a temporary trolley stop, insert a screwdriver into the hole
10" (25 cm) away from the front of the rail, as shown.
5. Checkto be sure there are 4 plastic wear pads inside the inner
trolley. If they became loose during shipping, check all packing
material. Snap them back into position as shown.
6. Slide the trolley assembly along the rail from the back end to
the screwdriver.
Trolley
aered
End
3ered
End
aered
End
Back Rails
(TO MOTOR UNIT)
)ered
End
Inner Trolley __