JMB 54386 Manual De Instrucciones página 7

REF.54386
Platform tilt adjustment
You can adjust the platform tilt by using these
keys.
This feature allows you to change the inclina-
tion of the platform, which can compensate
uneven shop floors.
CAUTION: To avoid damage to the equipment,
before tilting the platform, make sure the le-
veler screws are in their lowest position. This
will prevent the platform from digging into the
screws.
Platform position adjustment
The platform has two keys with which you can
adjust its position. One key is located on the
front, the other on the side.
Turning the key to the right will bring the plat-
form closer to you.
Turning the key counterclockwise will move it
away from you.
Platform extension
Loosen this key in the two sides of the platform.
Extend the platform.
TIghten this key in the two sides of the plat-
form.
Stabilization feature
To give more stability to the platform, you can
use the leveler screws.
Once the platform is in the desired position,
you can thread the screws until they press
against the bottom of the platform.
In this way, the platform will have more support
points and will be more stable.
· 7 ·