Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
NUMBER OF SCHEDULES
Up to 35 watering schedules per spigot can be programmed for complete watering customization.
RAIN DELAY
The user will be able to set a rain delay setting in the app that will tell the timer to pause all scheduled operations
for a period of time (for both spigots). The default will be 1 day (24 hours), and the user will have the ability to set
it for between 1 to 15 days. After the time runs out, the timer will resume scheduled operations.
□
The app must show clearly that the timer is in rain delay or not and allow the user to start or end Rain Pause.
□
If either spigot is opened due to button, mobile app, or voice control, the rain delay must be canceled.
□
When the Rain Pause starts, all valves must be closed.
□
The timer starts from when the user starts the rain delay.
□
The user can cancel the rain delay at any time.
ONBOARDING AND REMOVAL
Onboarding is done via QR code scanning, manual code entry, or QR-codeless capability. The QR code is placed
on the unit's label on the device or on the device itself, for example - via laser etching or printing. QR codes
are unique for each device. Scanning the QR code of a device already on another account will transfer it to the
scanner's account.
NOTE: If a user does not connect a gateway or if the
watering timer is out of range of the gateway, they will
only be able to operate and configure the watering timer
through the Hubspace app when it is within BLE range.
QR CODE OR MANUAL ENTRY ONBOARDING
The user scans the QR code or enters the code manually into the app.
QR CODELESS SETUP MODE ONBOARDING
To enable onboarding without the QR code, users can place the device into setup mode by pressing and holding
both buttons for 5 seconds. The LED's will then blink green to indicate this mode is active. The device will stay in
this mode for 5 minutes or until it is added to an account by the mobile app.
SETUP MODE IDENTIFICATON
When instructed to identify the device by the app in setup mode, the device will blink the LED.
DEVICE REMOVAL
When the device is removed from an account, or reset by the service, it may close the valve if it is open. Note that
this is done on a "best effort" basis and may not be possible or performed depending on the connectivity and
timing. However, the valve will be closed once the timer has completed. Devices do not know whether they are on
an account or not and it is entirely possible for a user to remove the device from their account remotely.
12
Publicidad
