YATO YT-86200 Manual De Instrucciones página 10

the higher the temperature, the faster the discharge process. If the
batteries are stored incorrectly, the electrolyte may leak. In case of
leakage, secure the leak with a neutralising agent, in case of elec-
trolyte contact with eyes, rinse eyes thoroughly with water, and seek
medical attention immediately. It is forbidden to use the device with
a damaged battery. If the battery is completely used, return it to a
specialist waste disposal centre.
Transport of batteries
Lithium-ion batteries are treated as hazardous materials according to
legal regulations. The user of the device can transport the product with
the battery and the batteries themselves by land. Additional conditions
do not have to be met. If you entrust transport to third parties (e.g.
courier service), follow the regulations for the transport of hazardous
goods. Before shipping, please contact a qualifi ed person. It is forbid-
den to transport damaged batteries. During transport, the disassem-
bled batteries should be removed from the product, the exposed con-
tacts should be secured, e.g. sealed with insulation tape. Protect the
batteries in the packaging in such a way that they do not move inside
the packaging during transport. National regulations for the transport
of hazardous materials must also be observed.
GUN OPERATION
All adjustments of the nozzle must be carried out with the power
supply disconnected. Make sure that the power switch is in the off
position.
Spray adjustment
By rotating the nozzle, you can adjust the shape of the spray from
mist to jet. It is recommended to carry out the tests by directing the
gun nozzle into a bucket or other container.
CAUTION! Do not press the power switch while rotating the nozzle.
CAUTION! The spray type aff ects the performance of the sprayer.
Switching on/off
Fill the tank according to the procedure described above.
Set the spray type
Direct the nozzle to the spray area.
Press and hold the power switch.
Water will start to come out of the nozzle.
Releasing the pressure on the power switch stops the operation.
During operation, control the amount of water in the tank so that the
tank is not empty. Stop of the liquid fl ow through the gun will cause
its damage as a result of the pump overheating.
CLEANING AND MAINTENANCE
Warning! Do not use fl ammable materials for cleaning and main-
tenance.
O R I G I N A L
10
GB
Unscrew the tank from the gun and empty it if other liquid than clean
water was sprayed; fi ll the tank with clean water and attach it to the
gun. Direct the nozzles into a bucket or other container and start the
sprayer for at least 30 seconds. This will allow rinsing the inside of
the gun with clean water. Unscrew the tank from the gun again and
empty it. Leave to dry.
Start the gun for a few seconds – this will remove the remaining
water from inside the gun. Caution! Too long gun operation without
water will lead to overheating of the pump and gun damage.
Clean the external surfaces of the gun with a slightly damp cloth,
then dry.
Caution! It is forbidden to clean the spray gun by directing a jet at it
or immersing it in water, diluent or other liquid. It is forbidden to use
sharp objects and/or abrasive cleaning agents to clean the guns.
Store the sprayer empty of water in a place that is inaccessible to
bystanders, especially children. The storage area should protect
against direct sunlight, moisture, and provide ventilation.
I N S T R U C T I O N S