Uline H-11217 Instrucciones De Montaje página 3

BOTTOM SHELF ASSEMBLY
NOTE: Bottom shelf is a two-piece design. One
end has a channel to rest shelf on top of the
leg brace on the outside legs. The other end
is flat and will bolt to the center leg's brace.
1. Place the end of each shelf piece (7) with the
channel across the leg brace of the outside legs.
Have two people hold up the end of the shelves that
face the center leg (1). Align the holes on the side of
the shelf pieces to the holes in the center leg brace.
Fasten shelf pieces to center leg brace with three
M8 x 65 hex bolts and three M8 nuts using a
13 mm wrench. (See Figures 4-5)
Figure 4
Figure 5
2. Fasten end of
each shelf piece
to the leg brace
of the outside legs
with six M8 x 35
hex bolts and six
M8 nuts per shelf
using a 13 mm
wrench.
(See Figure 6)
PAGE 3 OF 9
ASSEMBLY CONTINUED
Figure 6
TOP ASSEMBLY
1. To attach tabletop onto frame assembly, place
tabletop on a smooth, non-marring surface with
top side facing down.
2. Rotate assembled frame upside down and
align with pre-drilled holes in tabletop. Using
#28 blunt-end wood screws and drill with
flathead drill bit, attach frame to underside
of tabletop. (See Figure 7)
ONLY USE BLUNT-END WOOD SCREWS
NOTE: If holes in frame assembly and
pre-drilled holes in tabletop do not align,
loosen frame support bars and align holes.
Insert screws into pre-drilled holes
and re-tighten frame support bars.
Figure 7
3. Carefully set table upright and check all screws
for tightness.
1-800-295-5510
uline.com
PACKAGED WITH TABLETOP.
Wood
Screw
Tabletop
Wood
Screw
1123 IH-11217