Publicidad
Idiomas disponibles
Idiomas disponibles
Door Handle Assembly
1. Door handle and screws for door handle assembly are
separately in a plastic bag.
2. If the screws are in the door, remove the screws and
set aside.
3. Place the screw holes of the door handle to the screw
holes of the refrigerator door.
4. Fasten the handle with the screws. Ensure that the door
handle is firmly seated.
5. Close the screw holes with the cover caps on the side
where no door handle is mounted.
6. Stand the appliance upright again after swapping the
hinges.
7. Check the exact fit of the door seal and the appliance
door.
8. Reconnect to the mains power supply after three hours
at the earliest.
2.3
Setting up the appliance
Place the appliance
in accordance with the prescribed minimum clearances.
•
Set up the appliance in a dry, well-ventilated room whose ambient temperature
•
corresponds to the climate class for which the appliance is designed.
ATTENTION
APPLIANCE DAMAGE!
Leave the appliance to stand for 12 hours after transport to allow the refrigerant to
collect in the compressor. Failure to observe this may damage the compressor and cause
the appliance to fail. This would void all warranty claims.
CLIMATE CLASS
(SN) Extended temperature range
(N) Temperature range
(ST) Subtropical temperature range
(T) Tropical temperature range
Minimum clearances for ventilation
Air circulation at the rear, side and top of the appliance influences energy consumption
and refrigerating (depending on model). It is essential that the minimum clearances for
ventilation of the appliance are observed as shown in the following drawing. Otherwise,
the life of the device is shortened because the compressor is constantly in operation.
Unit dimensions in mm and degrees
a
b
560
575
b1
b2
c
610
1100
850
Setting up and connecting
TEMPERATURE RANGE
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
d
e
f
100
50
30
g
h
180°
1085
Page | 31
Publicidad
