Publicidad
Idiomas disponibles
Idiomas disponibles
LUBRICATION
/!k CAUTION:
The chain saw is NOT supplied filled with oil. It is essential to fill with oil
before use. Never operate the chain saw without chain oil or at an empty oil tank level, as
this will result in extensive damage to the product. Chain life and cutting capacity depends on
optimum lubrication. Therefore, the chain is automatically oiled during operation via oil outlet
Filling oil tank: (See Figs. 5a and 5b)
1. Set chain saw on any suitable surface with oil filler cap facing upward.
2. Clean area around the Oil Filler Cap with cloth and unscrew the cap by turning
it counter clockwise.
3. Add bar and chain oil (Craftsman Bar & Chain Oil, SAE30) until reservoir is full.
4. Avoid dirt or debris entering oil tank, re-screw oil filler cap and tighten.
Fig. 5a
Fig. 5b
Oil Filler Cap
Oil Reservoir
/_ CAUTION:
To allow venting of the oil reservoir, small breather channels are
provided between the oil filler cap and the strainer. To prevent leakage, ensure machine is
left in a horizontal position (oil filler cap uppermost) when not in use.
It is important to use only the recommended oil to avoid damage to the chain saw.
Never use recycled/old oil. Use of non approved oil will invalidate the warranty.
Checking
the Automatic Oiler
Proper functioning of the automatic oiler can be checked by running the chain saw and
pointing the tip of the Guide chain bar (7) towards a piece of cardboard or paper on the
ground. If an increasing oil pattern develops on the cardboard, the automatic oiler is
operating fine. If there is no oil pattern, despite a full oil reservoir, contact customer service
agent or approved service agent.
Caution:
Do not touch the ground with the chain. Ensure safety clearance of 12".
ASSEMBLING
THE EXTENSION
POLE
Align and insert the handle of extension pole into the shaft.
Rotate the locking collar clockwise to lock. (See Figs. 6a and 6b)
Note:
Make sure that the shaft is firmly locked
in place.
Fig. 6a
Fig. 6b
ASSEMBLING
THE EXTENSION
POLE
TO THE MACHINE
1. Insert the pole bracket into the saw.
(See Fig. 7)
Note:
Pole bracket
holds trigger
in "ON" position.
2. Slide the handle bracket onto clamping bolt.
3. Screw the knob tightly.
4. Plug saw power cord into receptacle
cord at end of inner pole. (See Fig. 8)
Fig. 7
,4X WARNING:,
Before attaching the power
cord of the machine to the power cord of the
Extension Pole, make sure that the tool is
switched off and unplugged from the power
supply. • When using this machine with the
Extension Pole, make sure to first attach the
power cord of the machine to the power cord
of the extension pole, and then attach the
power cord of the extension pole to power supply.
ELECTROCUTION HAZARD:
Never use the Saw or Extension Pole in an
area with overhead power lines or where the
branch being cut can come into contact with
overhead power lines.
18
19
Publicidad
