HDL Vídeo Porteiro Manual De Instrucciones página 12

Camera / Doorphone
Camera
Inclination
Setting
Camera Lens
For setting the camera lens sloping, slightly loosen the screw,
move the lever to the desired position and then tighten the
screw for fixing the selected position.
Note : The model "Pinhole" does not possess adjustment
of inclination of the lens.
Caution:
Avoid installing the camera such that strong lights or reflexes are
directly incident over the camera lens thus impairing the image
visualization.
Attempt to avoid installing the equipment next to intense magnetic
fields, such as transmission lines and antennas.
Avoid installing camera and monitor on locations subjected to strong
heat or excessive humidity.
Attention: The monitor is bi-volt equipment and therefore it could be
connected to 127 V or 220 V sockets.
Connections:
1-For distances
up to 40 m,
use 0.5-mm
C
diameter section
2
wires. For longer
distances up to
80 m, use 1-mm
section wires.
2-For connection
of electrical lock,
(optional) utilize
cables with the
minimum of
2
1,00mm (18AWG)
gauge.
Camera with a large angular
lens for a wide vision allowing
differently high persons to be
visualized in any of the three
positions. If installation is at
the Low position it is possible
to slope the lens upwards
such that the proper visitors'
visualization is allowed.
Similarly, if the installation is
at the High position the lens
can be sloped downwards.
For the Standard
usual to keep the lens with no
sloping.
Basic Connection
Monitor
Electrical
locker
(optional)
11
position it is
Camara
Button of
call of the
external unit