Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS
ES
ES
▶Power: 180W
▶Speeds: 3 levels
▶Fixed position
PT
PT
▶Safety grille
▶Blade diameter: 58cm
▶Manual switch on
EN
EN
▶Maximum air flow 9.833m3/h
▶220-240V~ 50Hz
FAN PARTS
FR
FR
a) Speed control knob (rear)
b) Propeller
c) Protective grille
d) Fixing screw
e) Support with wheels
ASSEMBLY
INSTRUCTIONS
▶Begin by placing the tubes numbered "4" into the U-shaped tubes
numbered "3". Securely fasten the tubes with the screws provided.
▶To install the wheels, refer to Figure 1:
• a. Insert the screw numbered "1" through the hole in the "U"
shaped bar.
• b. Place a washer numbered "2" on the bolt, followed by the wheel
numbered "3".
• c. Add another washer numbered "4" and finally screw the nut
onto the bar numbered "5".
▶Repeat the same process to install the other wheel.
▶Once both wheels are in place, you can fix the bar numbered "1" to
complete the base assembly. Secure using the screws provided.
Instruction manual
INSTRUCTIONS FOR USE
1. Place the base on a smooth and dry surface.
2. Make sure that the speed button is in the 0 position.
Connect the cord to an AC outlet.
3. The speed is adjusted by turning the controller, located
at the rear:
▶By means of the 3-speed system you can start the fan:
IMPORTANT NOTES
▶Place the fan on a flat, dry surface.
▶Before connecting the device to the mains, make sure that the
▶Plug the power cord into the mains socket 220-240V~ 50Hz.
▶If you do not use the fan for a long time, unplug the power cord from
▶Never attempt to disassemble the device where the motor is located.
▶If you detect any abnormality (such as unusual noise from the fan),
▶Make sure that no objects or liquids enter the interior of the fan
▶The fan should only be used in dry environments.
▶Protect the device from dust, moisture, sunlight and direct heat.
TILT ADJUSTMENT
To change the tilt angle of the fan head, move the fan head to the
desired angle.
CLEANING AND MAINTENANCE
▶Make sure that the device is switched off before cleaning.
▶Clean with a soft damp cloth, without detergent, aggressive liquids
▶Do not immerse the fan in water or any other liquid.
▶If the fan is not to be used for a long period of time, protect the fan
• POSITION 0: OFF position
• POSITION 1: first speed
• POSITION 2: second speed
• POSITION 3: third speed
switch is in the "0" position.
the socket.
switch off the device and unplug it immediately.
through any openings.
or solvents.
and store it or after cleaning it in a dry place.
Ref. 33933
Publicidad
