Pool Technologie UNO Instrucciones De Uso página 20

5. INSTALLING THE UV REACTOR
It is imperative that you read all the instructions in this manual before
For ease of maintenance, we recommend using a bypass.
-
The reactor must be installed in a vertical position (water inlet at the bottom)
-
Reactor
The reactor must always be located after the filter and before any other auxiliary appliance (heating).
-
A clear space of at least 1,000 mm must be provided for above the reactor for a JUSTSALT UV 25, or 700
-
mm for a JUSTSALT UV 15, for maintenance of the lamp and quartz.
The direction of flow from low to high must be respected.
-
The maximum network pressure must never exceed that of the reactor (3 bar).
-
If there is a risk of overpressure, it is recommended that an automatic bleed or relief valve be installed
to keep the line pressure below that of the reactor.
If a bypass is used for heating, the UV unit must be installed before the bypass.
-
The reactor is designed to be placed on the ground.
-
Please put on protective gloves before starting the installation.
700/1,000 mm
operating the reactor.
Downstream
valve
Bypass valve
Upstream
valve
6