Bemer Evo Manual De Instrucciones página 50

Sistema de terapia

Idiomas disponibles

7. COMMISSIONING

7.1 CONNECTING THE B.BOX EVO STAND, WALL MOUNT, AND BATTERY STAND

Take care to open the packaging of the BEMER Therapy System Evo in the correct place (see the

"Upside" symbol on the packaging) and ensure that the contents of the packaging cannot fall out

after opening. Having opened the packaging, first remove the B.Box Evo Stand or B.Box Evo Battery

Stand and connect it to the B.Box Evo controller. Connect the B.Box Evo Battery Stand (Premium

Set) or the B.Box Evo Stand (Basic Set) to the B.Box Evo. To do this, bring the B.Box Evo Battery

Stand close to the B.Box Evo as shown – the magnetic holder will then ensure a secure attachment.

Attaching the B.Box Evo Stand or the B.Box Evo Battery Stand

Before commissioning the B.Box Evo Battery Stand, the battery protection cover must be removed

from the B.Box Evo. To do this, use a Phillips screwdriver (PH 1) and be sure to replace the protective

cover after removal of the B.Box Evo Battery Stand / B.Box Evo Stand. Keep the protective cover

in a safe place.

Note on battery operation

As long as the B.Box Evo is supplied with voltage, the B.Box Evo Battery Stand will be continuously

charged. The current charging status can be seen on the display. In addition, the green LED on the

top of the unit lights up.

Note on operation with the B.Box Evo Wall Mount

The B.Box Evo Wall Mount is attached to the desired location on the wall using the two included

screws (4.5 x 35 mm) and dowels. Ideally, the chosen mounting position should take account of the

length of the applicator cables (2.5 meters). If longer distances are required between the B.Box Evo

and the application modules, the extension cord for Evo applicators (optional accessory) can be used.

2119-2208-764120_IFU Evo_USA_PEMF_764120-GC-3015_Inhalt_v08.indd 51

19.06.2023 09:50:36