Publicidad
Specifications
Brush
Motor
175 W
Protection
*Run Time
Class
IPX4
*60 Min
Brush
Speed
Pressure
150 RPM
24.61g/cm
*Run and Recharge times may vary dependent on ambient temperature.
Trouble Shooting
PROBLEM
Machine will not operate
Vacuum not operating
Poor water pick-up
No brush / scrub function
Little or no water flow
Machine just 'stops' while
operating
Failure to rectify the problem or in the event of a breakdown contact your Numatic dealer
Model - TTB1840NX/TTB1840NX-R
Vac
Brush
Motor
Sizes
100 W
400 mm
Water
Fluid
Capacity
Flow
18 L
0 - 0.7L/Min
Brush
Pad
Pressure
21.85g/cm
2
CAUSE
Battery not inserted correctly
Low battery charge
Faulty battery
Vacuum not turned on
If vacuum light on but no vacuum
operation
Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket filter clogged / blocked
Separator filter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged floor-tool blades
No brushes fitted
Brush overloaded
Clean-water tank empty
Incorrect water flow setting
Tank filter blocked
Too much load on the brush system
Pad
sizes
360 mm
Sound Pressure (LpA)
Uncertainty (KpA)
65
dB(A)
±0.5 dB
Dimensions
Width
= 520 mm
Length
= 850 mm
2
Height
= 1132 mm
SOLUTION
Insert battery (pages 15 - 20)
Recharge battery (See battery & charger instructions)
Replace battery (pages 15 - 20)
Turn on vacuum (pages 33 - 43)
Contact service agent
Empty waste-water tank (pages 50 - 55)
Remove and clean (pages 50 - 55)
Push tight connections (pages 50 - 55)
Remove and clean (pages 50 - 55)
Remove and clean (pages 50 - 55)
Clean and refit (pages 50 - 55)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Check and fit (pages 21 -26)
Reset machine (pages 33 - 43)
Fill clean-water tank (pages 27 - 32)
Adjust tap as desired (pages 27 - 32)
Remove and clean
If cut out engages then the surface is to rough & an
alternative machine may be required
64
64
Net
Gross
Weight
Weight (Full)
34 kg
52 kg
Cleaning speed
0 - 4.2 KPH
Hand Arm
*Charge Time
Vibration
*80%=60 Min
1.7 m/s
2
*100%=120 Min
EN
Publicidad
