Craftsman 27710 Manual De Las Instrucciones página 23

2
O To install bagger components to tractor
1. Discharge Chute
2. 3/8 Nut
3. Flat Washer
3
1. Support Bracket
2. 3/8 Carriage Bolt 1
3. 3/8 Lock Nut
4. 3/8 x 63,5mm Hex Bolt
5. 10,3mm (13/32") flat
washer
5
2
• Removedischargechutefrom rearoftractor.Unhookthe
two(2) strapsand pullchuteout and away fromtractor.
• Removethetwo (2) 3/8 nuts and fiat washers from the
bolts at the tractorback plate.
• Install the two uppersupportbracketsthrough the back
plateand tothe chassis,using the 10 x 19 mm(3/8"x3/4")
carriage boltsand Iocknuts supplied. T ightensecurely.
• Assemble both supportbracketsto the outsideof the
bagggersupporttube usingtwo each3/8 x 63,5mmhe0(
bolts13/32"I.D. fiatwashersand 3/8 Iocknuts from parts
bag."Rghten securely.
1.
2.
3.
1
3/8 Locknut _..
Flat Washer
Support T ube
Using the nuts and flat washers removed from tractor,
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
1. Hook
2. Discharge Chute
3. Back plate slot
3
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
23