ARO TZW8650 Manual De Instrucciones página 22

6. Loosen the two screws on the bottom hinge and remove it. Change the shaft on the
hinge to the opposite direction.
7. Place the bottom hinge on the opposite side and secure it in place with two screws.
8. Reinstall both adjustable feet. Make sure that they are installed on the opposite side
(smaller one on the side of the hinge).
9. Place the appliance back to the upright position.
10. Place the door back on the bottom hinge.
11. Make sure that the door is in the vertical position and can be closed easily.
Note:
After reversing the door hinge, the door gasket may get loose. Should you notice
a gap between the gasket and the cabinet, gently pull it out to seal the gap. A
correct gasket positioning is the key to prevent refrigerated air from escaping.
7. Operation
1. Connect the power plug to a suitable electrical outlet.
2. Use the thermostat to adjust the temperature.
For TLW8650/TLW8655/TLW8650E
Thermostat 0 – 7
0 - off
1 - warmest temperature
7 - coldest temperature
Recommended setting: 3 to 4
The settings (1 – 3) are generally intended to be used during the winter, and
the settings (5 – 7) during the summer. The higher the ambient temperature the
higher the setting should be used.
Note for model TZW8650/TZW8650E/TZW8655: Use the highest setting 5 only
to make ice-cubes or when frozen food is being stored.
3. Let the appliance operate for at least 3 hour before filling the food.
4. When not in use for a longer period of time set the thermostat to the 0 position and
disconnect the power plug from the electrical outlet. After unplugging wait at least
10 minutes before plugging in again.
5. Defrost and clean the inside of the appliance ( Cleaning and care).
Preparing the ice-cubes (only for model TZW8650/ TZW8650E/TZW8655)
1. Fill the ice-cube tray (not included) with fresh drinking water. Do not overfill.
2. Dry the bottom of the ice-cube tray and place it inside the freezer compartment. This
prevents the tray from freezing to the surface of the freezer compartment.
3. Set the thermostat to the 5 position and wait for 2 to 3 hours.
4. To remove the ice-cubes more easily hold the ice-cube tray under the running water.
For TZW8650/TZW8655/TZW8650E
Thermostat 0 – 5
0 - off
1 - warmest temperature
5 - coldest temperature
Recommended setting: 3
Note: thermostat for this model is located at
the back of the appliance.
22
GB