Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
of Carton
1 - Air Compressor
1-
Handle
4 - Self Tapping Screw
2-
Wheels
2 - Shoulder Bolts, 3/8
2-
Hex Nuts, 3/8
1 - Rubber Strip
Tools Required
for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1.
Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
Assemble
Handle
1.
Insert the handle inside the
compressor saddle and line up
the two bolt holes on each side.
2.
Install the four screws, two on
each side.
3.
Tighten securely.
Assemble
Wheels
It will be
necessary to
brace or support one side of the
unit when installing the wheels
because the compressor will have
a tendency to tip.
1.
Attach wheels with shoulder
bolts and nuts as shown.
2.
Tighten securely. NOTE: The unit
will sit level if the wheels are
properly installed.
The wheels and
handle do not
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble
Rubber
Strip
1.
Clean and dry underside of air
tank leg opposite wheels.
2.
Remove the protective paper
strip from the adhesive backed
rubber foot strip.
3.
Attach the rubber foot strip to
the bottom of leg. Press firmly
into place.
Scl_w
Shoulder
Wheel
Bolt
Rubber Strip
A00854
10_ ENG
Publicidad
