Publicidad
Idiomas disponibles
Idiomas disponibles
4.2 ASSEMBLY OF THE
CHARGING DOCK (Fig. 3)
NOTE The machine can be hung on the wall,
making sure that the rear hand grip is in its original
position.
The batteries can be charged directly on the
machine with its charging dock (Fig. 3.A).
NOTE The charging dock can be fixed to the
wall (Fig. 3.B) (with the screws and the plastic
dowels supplied, Fig. 1. K) .
4.3 ASSEMBLY OF THE RAIL
FOR WALL FIXING (Fig. 4)
Once the rail (Fig. 1. H) has been fixed to the wall
(with the screws supplied), slide the charging
dock (Fig. 4. A) and the loop (Fig. 4. B).
5. CONTROLS
5.1 BLADE CONTROL LOCKING
BUTTON (Fig. 5.C)
Allows operation of the blade control lever (Fig.
5.A).
5.2 BLADE CONTROL LEVER (Fig. 5.A)
Allows the blade (cutting device) to be operated.
NOTE The cutting device stops automatically
when the lever is released
5.3 SAFETY SWITCH (Fig. 5.B)
The safety switch, on the front handle, provides
additional safety, since it must be held down
together with the blade control lever in order to
operate the cutting device.
NOTE The cutting device stops automatically
when the lever is released
5.4 REAR HANDGRIP RELEASE
BUTTON (Fig. 5.D)
It's used to adjust the rear handgrip (Fig. 1.D) to 5
different positions in relation to the cutting means
to make trimming your hedges easier (par 6.4.1).
The handgrip must only be adjusted
when the machine is switched off.
6. USING THE MACHINE
IMPORTANT The safety standards to be
followed are described in chapter. 2. Strictly
comply with these instructions to avoid serious
risks or dangers.
6.1 PRELIMINARY OPERATIONS
Place the machine in a stable horizontal position
on the ground.
6.1.1 Checking and charging the battery
(Fig. 6)
Before each use check the batteries charge
status according to the instructions in the battery
booklet.
NOTE The machine works only with both
batteries inserted.
6.2 SAFETY CHECKS
Always carry out the safety checks before
use.
6.2.1 General check
Object
Handgrips (Fig. 1.C,
Fig. 1.D) and guards
Screws on the
machine and blade
Cooling air ducts
Blade (Fig. 1.B)
Guards
Battery (Fig. 1.F)
Machine
Levers, buttons, and
safety switches
EN - 7
Result
Are clean, dry and fixed
firmly to the machine
Correctly tightened
(not loose)
Not clogged
Sharp, not damaged or
worn, well sharpened.
Intact, undamaged.
No damage to the casing,
no liquid leakage.
No signs of damage
or wear. No abnormal
vibrations.
No abnormal sound.
They must move freely,
not be forced and when
released they must return
automatically and rapidly
to the neutral position.
Publicidad
