Publicidad
Idiomas disponibles
Idiomas disponibles
When the bucket is full, or when the bucket is not in the proper position> the Bucket Full light turns on
and the unit automatically shuts off.
Also> when bucket is out of position>the unit will beep 3 times.
The bucket must be replaced in the proper position for the dehumidifier
to work. The light will
be on and the dehumidifier
will not run if the bucket is not in the proper position.
The water bucket can be emptied in one of three ways:
1. Empty the bucket
manually.
When the bucket is full,
remove and empty it into a
large sink or tub. When
finished, replace it properly.
NOTE: To replace the bucket
properly,
make sure the
slots on the back of bucket
are positioned
correctly.
NOTE: Be careful while
taking out the bucket as it
can be heavy. It is advisable
to carry the bucket by
supporting it from bottom.
2. Place the dehumidifier
directly over drain.
The bucket has a threaded
hose connection which can be
left open. Drill a 1/4" (6.4mm)
to 1/2"(13mm) hole in the
center of the hose connection.
Once opened, the hose
connection will continually
drain water from the bucket.
NOTE: When inserting
the
bucket into the unit. Lifting
up the bottom tip of the
bucket lightly makes
insertion easily.
3. Attach a garden hose to
the threaded bucket drain
hose connection to carry
water to the drain, (HAND
TIGHTEN ONLY)
Be sure the hose doesn't kink
or bend. It should lie fiat from
the dehumidifier to the drain.
NOTE: Do not tighten the
hose excessively when
connecting it to the bucket.
Use a rubber washer and
tighten by hand firmly
without stripping the plastic
threads.
/
-9-
Publicidad
