Troy-Bilt TB575 EC Manual Del Operador página 4

KNOW YOUR UNIT
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds.
• Edging
• Decorative trimming around trees, fences, etc.
Other optional accessories may be used.
TOOLS REQUIRED:
• #2 Phillips screwdriver
• 3/8" Socket
D-Handle
Line Cutting
Blade
Cutting Head
4
Oil Fill Plug
Spark
Plug
Muffler
Starter
Rope Grip
On/Off Stop
Control
Shaft
Grip
Throttle
Control
Choke
Lever
EZ-Link™
Cutting Head Shield
Air Filter
Cover
INSTALL CUTTING ATTACHMENT SHIELD
WARNING:
the trimmer without the cutting attachment shield in place.
Use the following instructions if the cutting
attachment shield on your unit is not installed.
Use only the instructions that apply to the type of
shaft and shield that your unit is equipped with.
1. Place the cutting head shield onto the guard
mount bracket, making sure to align the
holes on the shield with the holes in the
guard mount bracket. (Fig. 1)
2. Take the 2 shield screws and screw each
one into the shield until finger tight.
Fuel
3. Using an appropriate screw driver, tighten
Cap
the screws until the shield is firmly in place.
Make sure the screws are tightened equally
so there is a balanced gap between the
bracket and the shield on each side.
ADJUSTING THE D-HANDLE
Primer
1. Loosen the bolt on the handle just enough
Bulb
to move it (Fig. 2).
2. While holding the unit in the operating position (Fig. 13), move the D-
handle to the location that provides the best grip.
3. Tighten the bolt until the D-handle is secure. (Fig. 2)
ASSEMBLY INSTRUCTIONS
To prevent serious personal injury, never operate
Cutting
Head Shield
6 in.
(15.24 cm)
Minimum
Screw (2)
Guard
Mount
Bracket
Fig. 1
D-Handle
Bolt
Fig. 2