Publicidad
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION
ATTENTION!
This unit is designed to be installed in a furniture cabinet.
Keep this information in mind when mounting the unit.
5.1 Delivery package
After unpacking, check that the delivery is complete and that all parts are free of possible
See image
transport damage.
1. - cooker hood
2. - reducer 150 - 120 mm
3. - non-return valve
5.2 Unit dimensions (mm)
See images
2b
2a
5.3 Safety distances
Observe the safety distances from the unit (calculated in mm).
5.4 Checking the furniture
1.
Check that the built-in furniture is positioned horizontally and that it has sufficient load-
bearing capacity.
Note: Follow the manufacturer's specifications regarding the load-bearing capacity of the
built-in furniture.
2. Make sure that the built-in furniture withstands temperatures up to 90 °C.
3. Make sure that the built-in furniture allows for embedding even after the cutting work is
done.
5.5 Installation steps
1.Cut the installation gap in the cabinet wall under which the hood will be mounted.
Use the following dimensions (mm) as a guide. See image
2. Insert the hood into the furniture body.
Make sure that the elastic clips are fixed on the furniture body on both sides.
3. Adjust the screws 1, 2, 3, 4 until the flanges of both sides are fixed in the furniture body.
See images
4d
4e
4. Installing the grease collector:
Position the grease collector in the support, until it is fixed. See image
5.6 Fitting the grease filters
ATTENTION!
By falling, the grease filter can damage the cooking zone below.
Hold the filter firmly by the two handles.
1.
Initially insert the filter on the opposite side of the control panel, above the rear fixing
channel positioned over the grease collector. See image
1
2c
2d
EN
4a
See image
4b
5a
24
See image
3
See image
4f
4c
Publicidad
