Publicidad
Idiomas disponibles
Idiomas disponibles
8.2 Operating errors
Failure
The LED lighting is on, but
the fan does not turn on.
Neither the LED lighting nor
the fan work.
The unit emits strong
vibrations.
Air intake power
is reduced.
9. CLEANING AND MAINTENANCE
To ensure optimal operation of the unit for a long period of time, clean and care carefully.
9.1 Cleaning products
ATTENTION!
Inappropriate cleaning agents can damage the surface of the unit.
Do not use sharp or abrasive cleaning agents.
Do not use cleaning agents with a high alcohol content.
Never use wire sponges or hard dish sponges.
Do not use special products for hot cleaning.
Use glass cleaners, glass scrapers or stainless steel care products only if they are
recommended in the cleaning instructions for the particular component.
Wash new cloths thoroughly before use.
9.2 Cleaning the unit
Clean the unit as directed to avoid damage to various components and surfaces from
improper cleaning with inappropriate cleaning products.
WARNING - Danger of explosion!
Strongly corrosive-alkaline or strongly acidic detergents can cause explosions in combination
with aluminum parts inside the dishwasher.
Do not use strongly corrosive-alkaline or strongly acidic detergents. Also, do not under any
circumstances use commercial or industrial detergents in combination with aluminum
parts, such as, for example, the grease filter.
EN
Causes and remedy of defects
The fan turbine is blocked.
The motor is damaged.
Turn off the unit and call an authorized person to carry out the
repair
LED module burned out.
The power cord is not plugged in properly.
Insert the plug firmly into the outlet.
The fan turbine is damaged.
The fan motor is not firmly attached.
The unit is not properly secured to the stand.
Shut down the unit and repair only with the help of qualified
service personnel.
Lower the unit and check that the bracket is in the proper
position.
Too much distance between the unit and the hob.
Readjust the distance respecting the safety distances.
The intake of fresh air in the room is not sufficient to
compensate for the exhaust air.
26
Publicidad
