AERMEC FCW 222V Manual De Uso E Instalación página 45

ELECTRICAL WIRING
WARNING: check that the power sup-
ply is disconnected before performing
operations on the unit.
The unit must be connected directly to
an electrical outlet or to an independ-
ent circuit.
Provide a 230V (±10%) power supply.
To protect the unit against short circuits,
fit a circuit breaker of max. 2A 250V to
the power line with a minimum con-
Electrical wiring
FCW223VN
FCW222VN
FCW323VN
FCW322VN
FCW423VN
FCW422VN
FCW22VLN
FCW32VLN
FCW42VLN
FCW52VLN
Front panel
Power supply terminal block
Base
tact opening distance of 3 mm.
The electrical power cable must be of the
H07 V-K or N07 V-K type with 450/750V
insulation rating if inside a tube or con-
duit. Use cables with double H5vv-F
type insulation for exposed cable instal-
lation.
Follow the wiring diagram supplied with
the equipment and shown in this docu-
ment when making the connections.
FCW223V
Motor
FCW222V
FCW22VL
Terminal block
FCW323V
FCW322V
Connection cable
FCW32VL
FCW423V
Motor
FCW422V
FCW42VL
Terminal block
FCW523V
FCW522V
Connection cable
FCW52VL
Motor
Terminal block
Connection cable
Cable cross section
Motor
Terminal block
WARNING
The unit must be correctly earthed; incorrect connec-
Connection cable
tion could result in electric shocks or fires.
Ensure that the installation is wired in
compliance with the laws and standards
in force, and with the instructions in
this manual.
All the parts and materials supplied on
site must comply with the local laws
and regulations.
FCW_2V
FCW_3V
FCW_VL
IG
Microprocess-
or controller
Terminal block
Connection cable
Microprocess-
or controller
Terminal block
Connection cable
FCW_2VN
FCW_3VN
FCW_VLN
2A
2
1.5mm
45