Westward 46V232 Manual De Instrucciones página 10

Westward Operating Instructions and Parts Manual
24. Assemble the tie rod to the axle spindles using two M12X30 hex bolts (C), four Ø12 flat washer (L) and two M12
hex lock nuts (I), Tighten, leaving oil enough that the spindles still pivot. See Figure 10.
25. Remove the M12 lock nut from the center pivot bolt. Assemble rear tongue section, the pivot bushing, the large
Ø12 flat washer (M) and M12 hex lock nut (I) onto the pivot bolts as shown in Figure 11.(The pivot bushing fits
into the hole in the tongue.) Tighten.
26. Fasten the tongue to the tie rod as shown in Figure 11, using a M12X30 hex bolt (C), two Ø12 flat washer (L)
and a M12 hex lock nut (I) . Tighten, leaving loose enough that the tongue can pivot.
27. Apply grease to the axle spindles now or use a grease gun after wheels are assembled.
2000LB STEEL DUMP CART
10
FIGURE 10
FIGURE 11
46V232