Publicidad
Idiomas disponibles
Idiomas disponibles
Westward Operating Instructions and Parts Manual
20. Assemble the tongue reinforcement angle to the back side of the axle supports as shown in Figure 8. Use two
M8X65 hex bolts (B), Ø8 lock washer (K), Ø8 Flat Washer (U) and M8 hex nuts (H). Don't tighten.
21. Make sure the center bolt (pivot bolt ) is inserted as far as possible through the axle channels and then tighten
the four bolts assembled in Figure 8,which fasten the front axle supports to the cart bed.
22. Connecting the front panel with the bottom panel by using six M8X16 round head bolts (F), Ø8 lock washer (K),
Ø8 Flat Washer (U) and M8 hex nuts (H). Then Connecting the front panel with the side panel by using six
M6X16 round head bolts (E), Ø6 lock washer (J), Ø6 Flat Washer (T) and M6 hex nuts (G). See Figure 9.
23. Assemble two corner caps to the front of the cart using four M6X16 round head bolts (E), Ø6 lock washer (J), Ø6
Flat Washer (T) and M6 hex nuts (G), and then tighten. See Figure 9.
2000LB STEEL DUMP CART
9
FIGURE 8
FIGURE 9
46V232
Publicidad
