Publicidad
Idiomas disponibles
Idiomas disponibles
Stand Installation &
Wall Mounting
Assembling / Removing the pedestal
Preparations
Take out the pedestal(s) and the TV from the packing
case and put the TV onto a work table with the screen
panel down on a clean and soft cloth (blanket, etc.).
Use a at and rm table bigger than the TV.
Do not hold the screen panel part.
Make sure not to scratch or break the TV.
Assembling the pedestal
1.
Place the pedestal(s) on the mounting pattern(s)
on the rear side of the TV.
2.
Insert the screws provided and tighten them gently
until the pedestal(s) is/are properly tted.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall mount bracket or repacking the TV.
Put the TV onto a work table with the screen panel
down on a clean and soft cloth. Leave the pedestal(s)
protruding over the edge of the surface.
Unscrew the screws that x the pedestal(s).
Remove the pedestal(s).
When using the wall mount bracket
Your TV is also prepared for a VESA-compliant wall
mount bracket. If it is not supplied with your TV, contact
your local dealer to purchase the recommended wall
mount bracket.
Holes and measurements for the wall mount bracket
installation;
VESA WALL MOUNT MEASUREMENTS
W
H
Hole a ern
Sizes (mm)
400
200
Screw Sizes
7
min. (mm)
Length (X)
max. (mm)
10
Thread (Y)
M6
Antenna Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket located on the left side of the TV
or satellite plug to the SATELLITE INPUT (LNB) socket
located on the rear side of the TV.
Left side of the TV
Rear side of the TV
If you want to connect a device to the TV, make
sure that both the TV and the device are turned o
before making any connection. After the connection
is done, you can turn on the units and use them.
English - 5 -
Other Connections
If you want to connect a device to the TV, make sure that both the TV and the device are turned o before making
any connection. After the connection is done, you can turn on the units and use them.
Connector
Type
Cables
HDMI
Connection
(back&side)
SPDIF
SPDIF
(Optical Out)
Connection
(back)
HEADPHONE
Headphone
Connection
(back)
USB
Connection
(side)
CI
Connection
(side)
LAN
Ethernet
Connection
(back)
LAN / Ethernet Cable
When using the wall mounting kit
Device
(contact your dealer to purchase one,
if not supplied), we recommend that
you plug all your cables into the back
of the TV before mounting on the
wall. Insert or remove the CI module
only when the TV is SWITCHED
OFF. You should refer to the module
instruction manual for details of the
settings. The USB inputs on the
TV support devices up to 500mA.
Connecting devices that have current
value above 500mA may damage
your TV. When connecting equip-
ment using a HDMI cable to your
against parasitic frequency radiation
and trouble-free transmission of high
tent, you have to use a high speed
shielded (high grade) HDMI cable
with ferrites.
English - 6 -
-
Publicidad
