Descargar Imprimir esta página

IPC N. Royal Jet Manual De Instrucciones página 21

Hidrolimpiadora por agua fria

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 47
USING THE MULTIREG
ADJUSTABLE NOZZLE
(fig. 10)
Pressure must be selected
with the gun switched off.
Low pressure washing and
detergent suction.
Shift the nozzle towards the
gun.
Washing at high pressure
with a concentrated jet of
water
Turn the nozzle in a clockwise
direction.
Washing at high pressure
with a fan-shaped jet of
water
Turn the nozzle in an anti-
clockwise direction.
USE OF THE DOUBLE LAN-
CE (fig. 11).
The double lance allows the
operator to select a low or high
pressure jet. The pressure is
selected with the gun in pos.
1.
High pressure: pos. 2.
Low pressure and detergent
intake: pos. 3.
REGULATING PRESSURE
This chapter concerns only
those models provided with
the "pressure regulating"
device. The pressure regula-
tor, fig. 12, allows the operator
to adjust the working pressu-
re. When knob C is turned
in an anti-clockwise direction
(B) (minimum), the working
pressure is reduced.
English
ADVICE ON USING DETERGENTS
This cleaner has been designed for use with the detergents
supplied or recommended by the manufacturer.
The use of other detergents or chemicals may influence the
safety of the cleaner.
1)
For environmental compatibility, we recommend a rea-
sonable use of detergents (fig.9), according to the instructions
on the pack.
2)
From the range of recommended products, choose the
FIG.10
one most suited to the washing job to be done and dilute it
with water according to the instructions on the pack or in the
catalogue of the detergents most suited for the type of hot or
cold water cleaner.
3)
Ask your dealer for the detergents catalogue.
OPERATING PHASES FOR CORRECT CLEANING WITH
DETERGENTS
1) Prepare the solution of detergent at the concentration
most suitable for the type of dirt and the surface that is to be
washed.
2) Start the cleaner, turn on the detergent tap (if present),
switch on the detergent suction control on the lance (fig. 10)
and spray the dirty surface with the diluted product, working
from bottom to top.
Let it react for a few minutes.
3) Rinse the whole surface well from top to bottom at high
FIG.11
pressure.
4) After using with detergent, flush out the intake circuit; place
the detergent suction hose (fig. 8) in a tank of clean water and
let the pump run for 1 minute with the dosing tap turned fully
on and the lance in detergent delivery condition.
FIG.12
- 21 -

Publicidad

loading

Este manual también es adecuado para:

N. royal tecDs 2250tDs 2650tDs 3160tDs 3175t