Publicidad
Brentwood Assembly Instructions
Fig. 11b
A-FRAME ATTACHES
HERE
Fig. 11f
x4
1-1/2''
2 FOR FUN SWING
MOUNTS HERE
1-1/2''
2-1/4''
Carriage Bolt
8" min.
2"
E. 2 For Fun Supports
1. Along top of Swing Beam mark placement for 2 For Fun
27-1/4''
30-1/2''
2'' x 4'' Supports as shown in (Fig. 11b).
25-3/4''
28-1/2''
2. Position four beam brackets (right and left) in position on
beam making certain the outside of the braces are 17'' apart
and the nailing edge of the bracket is flush with the top of the
beam (Fig. 11c). Note: 2 For Fun Beam Brackets must be
placed a minimum of 8" from any adjacent structure or
accessory (Fig. 11d). Attach using three 2-1/2'' screws per
11-3/4''
13-1/2''
bracket.
10-1/4''
11-1/2''
3. Drill two 2'' x 4'' x 22'' supports as indicated in (Fig. 11e).
Attach four swing hangers to the supports using 5/16'' flat
washers and loc nuts as shown in (Fig. 11f).
4. Center supports across beam, mark and drill 3/8'' holes
(Fig. 11c). Attach using two 2-1/4'' Carriage bolts, 5/16"
flat washers and loc nuts per bracket (Fig. 11c).
22
Loc Nut
Washer
(3)
2-1/2''
screws
per joint
17"
8" min.
side view
Drill 3/8" Holes
22"
top view
18"
Fig. 11c
Fig. 11d
Fig. 11e
2"
Publicidad
