Publicidad
Brentwood Assembly Instructions
M. Climbing Wall.
1. Attach (9) 1'' x 4'' boards to (2) 2'' x 4'' boards and
install on unit as shown in (Fig. 19).
Note: There is a 2-3/4'' Gap between each
Climbing Wall 1'' x 4'' Board.
2. Attach Climbing Wall to unit as shown in
(Fig. 19a).
Climbing Rock Wall will require
8 8 C C l l i i m m b b i i n n g g R R o o c c k k s s
Fig. 19b
(2) 1-1/4'' Hex Head Bolts
M. Climbing Rock Installation
1. Mark locations of Climbing Rocks on the Climbing
Wall in a pattern that will easily allow your child to
climb to the deck. Make sure the bolt hole locations
are clear of wall supports before drilling.
2. Drill holes through the wall at the desired locations
using a 3/8" drill bit. Install Climbing Rocks as
shown in (Fig. 19b).
3. Make sure the Climbing Wall and Climbing Rock
connections are secure before allowing any children
to play on the Climbing Wall.
N N O O T T E E : :
(2)"T" nuts
3/8" Holes
Rock
(1) Loc Washer per bolt
(1) Flat Washer per bolt
Fig. 19
2-1/2'' screw
Fig. 19a
30
TOP
(2)
2-1/2'' screws
(Per joint)
(3)
2-1/2'' screws
(Both Sides)
Publicidad
