Publicidad
Brentwood Assembly Instructions
Fig. 24
1-1/2"
(2) 2-1/2''
screws per joint
S. Lookout Mountain Attachment:
1.
Assemble the wall support as illustrated in (Fig. 24). Use three 2-1/2" screws to attach the 2" x 4" boards
and two 2-1/2" screws per joint for the remaining assembly.
2.
Place the top of the wall in front of the opening of the climbing unit. Center the top of the wall within the
opening of the unit. Note: The edge of the wall should be firmly positioned against the climbing unit (see
Fig. 24a). Do not attach the wall at this time.
3.
Note the location of four holes in the sides of the wall (two each side). These holes will be used to secure the
stakes and bracing. Mark the locations of these holes on the ground directly below the position of the holes
on the wall. Remove the wall from the unit.
4.
Dig four (4) holes approximately 12" below grade at the hole locations shown in (Fig. 24a).
5.
Pound the 18" stakes into the ground at the proper hole locations. Leave approximately 6" of each stake
above grade. Level the grade around the stakes to assure the base of the wall is securely seated.
12"
2-1/2'' screw
15-1/2''
brace
dig (2) 12" deep holes
Note: If stakes are not close enough to the wall to be secured, dig
out the area around the stake(s) and reposition them until the
wall and stakes meet. Fill in any ground removed and pack
firmly.
36
Fig. 24a
hole locations
stake
2'' x 4'' x 17-1/4''
Publicidad
