Publicidad
Idiomas disponibles
Idiomas disponibles
5. MAINTENANCE
5.1
Warning
■ Remove the test leads on any input before opening the
case.
■ Do not operate the clamp-on probe without a battery
case cover.
■ To avoid electrical shock, do not attempt to perform any
servicing unless you are qualified to do so.
■ To avoid electrical shock and/or damage to the
instrument, do not get water or other foreign agents into
the probe.
5.2 Cleaning
■ To clean the probe, wipe the case with a damp cloth and
mild detergent.
■ Do not use abrasives or solvents.
■ Do not get water inside the case. This may lead to
electrical shock or damage to the instrument.
5.3 Battery Replacement
■ The Clamp-On Meter Model 514 is powered by a 9 V
battery. The
when the supply voltage drops below proper operating
range. This indicates that the battery needs to be
changed.
■ The meter must be in the OFF position and disconnected
from any circuit or input.
■ Place the meter face down and loosen the battery cover
screw with a screwdriver.
■ Replace the old battery with a new 9 V battery.
■ Replace the battery compartment cover and tighten
down the screw.
24
symbol will appear on the LCD display
Clamp-On Meter Model 514 - User Manual
Publicidad
