G Operating instruction
Controls and Displays
1
MODE selection button
2
Two-wheeler mode (12 V/0.9 A)
3
Car mode (12 V/4.0 A)
Old-timer on-board power supply mode
4
(6 V/4.0 A)
Mode for charging in low ambient
5
temperatures (6 V or 12 V)
Lithium mode
6
(12.8-V 4-cell LiFePO4/3.0 A)
7
Mode for battery recovery (12 V/4.0 A)
A
Battery charging status indicator
VOLT: current voltage of the connected
B
battery
AMP: current charging current
C
according to selected mode
D
Flashing: no battery connected
Value of the current charging voltage/
E
charging current
Fault symbol: battery chemically defective
F
('dead')
Flashing: battery connected with polarity
G
reversed
Thank you for choosing a Hama product.
Take your time and read the following instructions and infor-
mation completely. Please keep these instructions in a safe
place for future reference. If you sell the device, please pass
these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2
Risk of electric shock
This symbol indicates product parts energized with a
dangerous voltage of sufficient magnitude to constitute a
risk of electric shock.
2. Package Contents
• Automatic battery charger
• These operating instructions
3. Safety Notes
• This product is not intended for use by persons, including
children, with limited physical, sensory or mental abilities
or lacking in experience or knowledge, unless they are
supervised by a person responsible for their safety or have
been instructed on how to use the product.
• Children are not permitted to play with the device. Children
may not clean the product or perform user maintenance
without supervision.
• Protect the product from dirt, moisture and overheating, and
only use it in a dry environment.
• Do not drop the product and do not expose it to any major
shocks.
• Do not operate the product outside the power limits given in
the specifications.
• Connect the product only to a socket that has been approved
for the device. The electrical socket must always be easily
accessible.
• Disconnect the product from the network using the power
button – if this is not available, unplug the power cord from
the socket.
• Lay all cables so that they do not pose a tripping hazard.
• Do not bend or crush the cable.
• Do not cover the product – there is a risk of overheating.
• Keep the packaging material out of the reach of children due
to the risk of suffocation.
• Do not modify the product in any way. Doing so voids the
warranty.
Warning – Batteries
• Do not short circuit the batteries/rechargeable batteries
and keep them away from uncoated metal objects.
• Do not tamper with or damage/heat/disassemble the
batteries/rechargeable batteries.
• Do not charge frozen batteries.
• Before getting started, check whether there are any
damages to the battery you wish to charge. A damaged
battery must not be charged!
• Do not cover the battery during charging.
• Batteries can generate explosive gases during charging
and release them into the environment. Make sure there
is adequate ventilation and avoid any sparking.
• Do not leave the battery unattended for a longer time
period during charging!