Match light
1.
If the burner will not light after several attempts then the burner can be match lit, before using the match
allow 5 minutes for any accumulated gas to dissipate.
2.
Clip a paper match on one end of the lighting rod.
3.
Light match.
4.
Hold lighting rod and insert lighted match right next to the burner ports or ceramic file.
5.
Push and turn the designated control knob to
6.
Burner should ignite immediately.
Lighting Instructions
Make sure the lid is open.
1
Push and slowly turn the side burner knob to
position. Keep knob pressed in until the burner is lit. Once
2
it is lit, continue to press and hold for another 15 seconds to
ensure the burner stays lit.
If burner does not light within 5 seconds, turn the knob to
3
OFF position and repeat the lighting procedure.
If burner fails to light after step 3, turn the knob to OFF
4
position, wait 5 minutes, then repeat the lighting procedure
or light by match.
/HIGH.
12
continued
/HIGH