Publicidad
Idiomas disponibles
Idiomas disponibles
5. WAYS OF CLEANING
5.1. General Cleaning
5.2. TURN ON THE HEATER FUNCTION
5.3. Put a cleaning product to enhance cleaning
If using a cleaning product, you need to wash the item again with clean water,
or using clean water go on cleaning 90S, in order to clear away the cleaning product.
Only using tap water
Put the item to be cleaned on the mesh screening, then fi ll
the water. Ensure the item is immerged in the water;
1 the water level should above the "MIN-" marking, but
does not exceed the "MAX" marking. Put in the plug and
press the "ON" button.
Press "SET" button, choose one circle from 280/380/480S,
then press "ON" button, the unit start to work.
Note: While cleaning, the fi lth appears on the instrument and
looks like «smoke». Meanwhile, the clean water will get dirty.
The item is clean if there is no «smoke», no need to clean it one
more time. (Usually in 180s is su cient). If the water is dirty,
change it with clean water. Continue with cleaning another
item.
Put the item on the mesh screening, and then put the
mesh screening into the stainless steel tank. Keep the item
immerged in the water, ensure the water is above "MIN-"
marking but does not exceed the "MAX-" marking.
Press the "TC" button, the heater is working, around 40
minutes later, the temperature of the water is about 65°C,
the heater will auto shut o .
To reduce the time of heating, put in some warm water, but
don't put in boiled water.
Press "SET" button, choose one cycle from 280/380/480S,
then press "ON" button, the unit start to work.
Note: Using 65°C warm water, can enhance cleaning.
Keep the item is immerged in the water, with the cleaning product.
"MIN" marking but does not exceed the "MAX" marking.
Note: The liquid soap is neutral, it is a "soft" chemical liquid.
Press "SET" button, choose one circle from 280/380/480S,
then press "ON" button, the unit starts to work.
17
Publicidad
