cecotec 09940 Manual De Instrucciones página 52

ENGLISH
Cleaning the Mixed brush
Fig. 6
- Move the rotary-brush release button with the finger and remove the cover on the same
side of the brush.
- Remove one of the brush's ends as shown in Figure 6.
- It is important to remove any dirt residue that may have settled on the rotary shafts of the
brush.
- If you decide to wash the brush, all parts must be left to dry. Assemble the pieces back in
order to use the brush again.
Removing the battery
Press the battery release button and remove the battery as shown in Figure 4. Store the
battery in a plastic bag and leave it in a dry place.
Storing the vacuum cleaner
If the robot is not going to be used for a long time, remove the battery and store it in a dry and
safe place.
6. TROUBLESHOOTING
Problem
The vacuum cleaner does
not work.
The suction power
decreased and the vacuum
cleaner makes a lot of
noise.
Insufficient operating time
after charging the vacuum
cleaner.
(The battery life may vary
according to the room
temperature).
52
Possible cause
Battery is discharged.
The metallic tubes, floor
brushes, battery or the
appliance itself are not properly
assembled.
The dirt tank is full.
The filter is too dirty, the electric
rotary-brush inlet is obstructed,
or the brush is blocked.
Insufficient charge time.
Battery life has been exceeded.
Possible solution
Charge the vacuum cleaner.
Make sure all parts of the
vacuum cleaner are correctly
assembled.
Clean the dirt.
Clean or replace both filters.
Clean the dirt inside the
electric rotary brush.
Fully charge the battery
following the instructions in
this manual.
Batteries are easily recycled.
Go to the closest maintenance
point and buy new batteries.