Publicidad
Idiomas disponibles
Idiomas disponibles
8. Disposal
DO NOT dispose of the batteries in household waste.
Dispose of the batteries according to the local regulations
dealing with the disposal of these special materials
(e. g. to the collecting points).
The device is made of a combination of plastic and stainless steel. Be
sure to dispose of it in accordance wilh local regulations as unsor-
ted municipal waste. You may recycle it at your local community or
appliance recycling center.
9. Electromagnetic compatibility
Guidance and Manufacturer's Declaration
1) This equipment needs to be installed and put into service in accor-
dance with the information provided in the ACCOMPANYING DO-
CUMENTS;
2) IMMUNITY TEST LEVELS for basic safety and essential perfor-
mance of ME equipment and ME systems should be chosen based
on a high probability of maintaining basic safety and essential per-
formance, and shall be according to the professional Healthcare
facility environment, home Healthcare environment, and special
environment, based on the locations of intended use.
3) HOME HEALTHCARE ENVIRONMENT is a dwelling place in which
a patient lives or other places where patients are present, exclu-
ding professional Healthcare facility environments where opera-
tors with medical training are continually available when patients
are present. Such as schools, outdoors, homes, vehicles, hotels and
guesthouses.
EXAMPLE: As indicated in Table 6 of IEC 60601-1-2: 2014 for ME
EQUIPMENT, a typical cell phone with a maximum output power of
2W yields d = 3.3m at an IMMUNITY LEVEL of 3V/m.
30
A1 Electromagnetic Emissions
For all EQ UIPMENT and SYSTEMS
Guidance and manufacture's declaration - electromagnetic emission
The VP-M10 is intended for use in the electromainetic environment
specified below; The customer or the user of the P-M10 should
assure that it is used in such an environment.
Emission test
Compliance
RF emissions
Group 1
CISPR 11
RF emissions
Class B
CISPR 11
Hamnonic
Class A
emissions IEC
61000-3-2
Voltage
Complies
fluctuations/-
flicker
emissions IEC
61000-3-3
Electromagnetic
environment-guidance
The VP-M10 uses RF energy
only for its internal function.
Therefore, its RF emissions
are very low and are not likely
to cause any interference in
nearby electronic equipment.
The VP-M10 is suitable for
use in all establishments,
other than domestic and
those directly connected to
the public low-voltage power
supply network that supplies
buildings used for domestic
purposes.
31
Publicidad
