Lubricating The Guide Bar And Saw Chain; Adjusting The Shoulder Harness - Echo MTA-PP/E Manual De Instrucciones

Before you start
Correct cold ten- Chain needs ten-
sion sioning
Side link contact- Drive link tangs
ing guide bar hanging out of
guide bar

Lubricating the guide bar and saw chain

Adjusting the shoulder harness

 Tighten gearcase cover nuts to 8 - 9 N·m (71 - 80 in. lbs.)
Do not over-tighten nuts. Damage may result.
8.
 All chains require frequent adjustment.
9.
Correct warm
tension
Three mm (1/8")
between side
link and guide
bar at bottom
1.
2.
 The discharge volume of the automatic oiler is preset to de-
liver 3 to 4 ml/min. at normal operating RPM. During heavy
or dry cutting conditions the oil discharge volume may be
adjusted to assure adequate lubrication. Refill the oil reser-
voir with each tank of fuel.
 To prevent plastic deterioration, do not use synthetic or sili-
cone based oil.
1.
2.
3.
 Make sure all hooks and adjustment devices are secure.
 The shoulder harness is fitted with an emergency release
function. In case of emergency, pull up on the collar (A) to dis-
connect the machine from the strap.
10
IMPORTANT
Keep chain properly tensioned at all times.
NOTE
Connect spark plug cap.
Wipe debris from around oil fill cap.
Remove oil fill cap and fill reservoir with a quality, low viscos-
ity guide bar and saw chain oil.
NOTE
IMPORTANT
Hook the strap hook to the hanger on the outer tube.
Wear the shoulder strap so that the hook stays at your right
hand side.
Adjust the length of the shoulder strap so that you can hold
and operate the machine comfortably.
IMPORTANT