Publicidad
Idiomas disponibles
Idiomas disponibles
VERY IMPORTANT, make sure earth is connected before connected
7.2 CONNECTING TO ELECTRICITY SOURCE.
The machine has a display so that the user can see the voltage supplied to the machine before the voltage
reached the electrical components and causes any damage.
To connect the machine, do the following.
1.
Connect the socket to the electrical box socket. This way the electricity will not reach the motor and you
can see the voltage coming into the machine.
WARNING: the transformer has a tolerance of
these limits are passed then you will break the transformer
2.
Turn the power switch (STAR-16 GO) or switch selecting the bending direction (STAR-20) and the green
light will light up.
If the voltage appears on the display, but the green light does not light up, it is because there is an active
alarm: the emergency stop button is pressed or the bending plate protection is not in its working position.
If the red light is on, it is due to an overload in the motor.
3.
Step on the pedal to check which way the plate is turning. MAKE SURE THERE ARE NO MANDRELS OR
ACCESSORIES ON TOP OF THE MACHINE.
STAR-16 GO
Position 0.
Machine disconnected.
Position 1.
Connected machine with clockwise turn bending plate.
Position 2.
Connected machine with counterclockwise turn bending plate (STAR-20).
When connecting the machine, make sure the machine is turning in the way the sticker indicates, this
will avoid accidents with the accessories on the bending plate.
If it doesn´t turn the right way, please change the phases.
±10%
Machine 400V = 360V min / Max 440V max
Machine 230V = 207V min / Max 253V max
STAR-20
13
over and below the specified tension requirement. If
ENGLISH
Publicidad
