Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Swash Installation
Please read these instructions carefully before
installing the Swash. Failure to do so could
result in flooding, leaking, or damage to the
product.
NOTE: Steps may vary by type of seat
and toilet.
1. Existing toilet seat removal
a. Lift hinge covers and use a screwdriver
to remove the
mounting bolts.
b. remove toilet seat and keep for
future use.
2. Turn off water supply valve and flush
toilet
a. Turn water valve off to stop the flow of
water.
b. Flush toilet and hold down handle to
completely empty tank.
c. Disconnect water supply line from toilet
tank
NOTE: Do not disconnect from the
water supply valve.
Step 2c
NOTE: You may wish to place a container under
the tank to catch excess water.
Do not continue without completing the above
steps. Failure to do so could result in flooding,
leaking, or damage to the Swash.
12
3. Connect the top of the T-Valve to the
incoming water connection on the
bottom of your toilet tank
NOTE:
The T-Valve connects to the fill valve
directly under your toilet tank—it does
not connect at the wall.
Check to ensure the rubber washer sits
flat inside of the T-Valve.
Only connect to the cold toilet water
supply line.
If your water supply line is rigid you
may need to replace the water supply
line before continuing.
4. Connect the water supply line coming
from the wall to the bottom of the T-Valve
Steps 3,4
Continued following page
Publicidad
