Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Seat Cleaning, Removal, & Nozzle Cleaning
Unplug the Swash from the power source before cleaning or removing the seat.
Seat cleaning and removal
Use a soft, damp cloth and mild cleanser
(such as dish soap, Simple Green or Windex)
to wipe down the seat. DO NOT scrub or
use harsh, abrasive products to clean the
seat. DO NOT use thinner, benzene, acidic
chemicals, chloride, or hydrochloric acid
detergent. This may result in corrosion to
the metal parts or discoloration or scratches
to the bidet body. For a more thorough
cleaning, you may remove the bidet seat.
To remove the seat, press the Quick Release
button on the right side of the seat, and
slide the seat forward off of the mounting
plate and toilet.
NOTE: Be cautious of leaving home and
beauty products in contact with the
bidet seat, as irreversible discoloration
can result. Most stains can be removed
using a 1:1 mix of rubbing alcohol
and water and a soft cloth or towel.
However, some permanent stains are
the result of substances left on the seat
while the seat heater was activated. Be
cautious of home and beauty products
(including, but not limited to: various
hair and air freshener sprays, lotions,
body wash, skin tanners, body butters,
and oils) that come into contact with
the seat. Wash off any substances that
come into contact with the seat as soon
as possible. If necessary, replacement
seat parts can be purchased through
Brondell customer support.
26
CAUTION
Nozzle cleaning
There are two ways to initiate nozzle cleaning:
NOTE: The nozzle cleaning function will
not work if the seat is occupied, or if
the seat sensor has been overridden.
1. Regular cleaning
a. Press the Nozzle Cleaning button on the
control panel.
b. Nozzle will extend into the toilet bowl and
self-clean 3 times with cold water.
c. Nozzle will retract when finished.
d. Pressing the Stop button at any time will
cancel the nozzle cleaning process.
2. Intensive cleaning
a. Press the Nozzle Cleaning button for 3
seconds.
b. Nozzle will extend into the toilet bowl and
will self-clean 10 times with hot water.
c. Nozzle will stop cleaning and will stay
extended for 5 minutes to allow for
manual cleaning.
d. Gently clean the
nozzle manually
with a soft cloth or
toothbrush.
e. After 5 minutes,
nozzle will perform
a self-cleaning rinse
10 times before retracting.
f. Pressing the Stop button at any time will
cancel the nozzle cleaning process.
g. Pressing the Nozzle Cleaning button
during a self-clean will interrupt the
process; resume self-cleaning by pressing
the Nozzle Cleaning button again.
Step 2d
Publicidad
