Publicidad
Idiomas disponibles
Idiomas disponibles
3. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet and dolly. NOTE: Flat washers are not required with all units.
4. Insert casters into bottom of rear caster dolly by placing stem of caster into holes
provided. Apply pressure and twisting motion until casters snap into place.
5. With tank drain facing you, take caster foot marked with the letter A and place
in slot on left side of tank also marked with the letter A and secure with screw
provided.
6. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B and secure with screw provided.
7. Insert casters into feet by placing stem of caster into holes provided. Apply pressure
and twisting motion until casters snap into place.
8. Return tank to upright position.
9. If an accessory basket came with your unit, place basket with curved surface against
tank on rear caster dolly assembly. Push downward until basket snaps onto dolly. The
basket is not included with all models.
PLASTIC TANK WITH REAR WHEEL BASKET
You will find two casters, two large rear wheels, one axle, rear dolly/basket, two caster feet,
four screws, two washers, two hair pin clips. If your vacuum is 16 U.S. gallons (60.5 liters)
or larger you will also find two screws, two metal flat washers and two square nuts with
your wet/dry vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside
down so that the bottom is facing up.
2. Place one hair pin clip in one end of axle. Slide one washer down the length of the
axle to rest on the hair pin clip. Slide wheel onto axle next to washer. Be sure flat side
of wheel hub is facing outward.
ASSEMBLY (CONT'D.)
Screw
Caster
Foot
Screw
Caster
Foot
PAGE 7
Publicidad
