Silverline 244980 Traducción Del Manual Original página 7

Accessories
• Accessories for this tool, including spare Punches and Dies are available from your Silverline
stockist. Spare parts can be obtained from your Silverline dealer or www.toolsparesonline.com
Maintenance
WARNING: Always disconnect from the air supply and depressurise before cleaning or carrying
out any maintenance.
Replacing the punch and die
• Inspect the condition of the Punch (4) periodically. If dull or damaged, the cutter needs to be
replaced:
1. Loosen the Locknut (5) using a 22mm spanner (not supplied) then unscrew and removed
the Die (6)
2. Unscrew and remove the Punch Holder (3), using a 9mm spanner (not included)
3. Remove the worn Punch (3) from the Punch Holder and replace with a new Punch
4. Re-fit the Punch Holder and tighten securely
5. Screw the Die back into the nibbler until the bottom of the Punch is flush with the bottom
of the Die
6. Rotate the die into the position required by the workpiece
7. Hold the Die steady with a 15mm spanner (not supplied) on its flats and retighten the Locknut
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that
when an air tool fails to work it is generally because the internal workings have corroded due to
dirty, wet air and failure to follow the instructions given below.
Daily maintenance procedure
If an inline lubricator is not fitted to the air supply, the tool must be manually lubricated:
1. Disconnect from the air supply
2. Pour 3-4 drops of oil into the air intake
3. Reconnect the air supply and operate the machine several times to lubricate all internal workings
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: www.toolstream.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
De Keten
00004
5651 GJ
Eindhoven, Netherlands
Disposal
• As with other power tools, air tools should not be disposed of with household waste
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
Air Nibbler
7