Hisense FT3B213 Serie Manual De Operación página 34

Reverse the door
When reversing the door, the cabinet
installation can refer to Built-In Fridge
Freezer installation instructions.
1. To ensure the doors are fully
closed/sealed, conduct a test on
both doors following the installation
of decor door, such as using a sheet
of paper in-between the unit door
and its seal and closing the decor
door and seeing if there is any
tension observed when pulling the
sheet of paper-the sheet should hold
in place and not fall out.
2. For reversing the door, the hole
covers need to be removed from the
current location and refitted to cover
the new holes. If these break when
removing and can be replaced by
accessory bag.
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
neutral soap in order to remove the
typical smell of a brand new product,
then dry thoroughly.
Installation Positioning
WARNING
Before installing, read the instructions
carefully for your safety and the
correct operation of the appliance.
NOTE
• Position the appliance away from
sources of heat such as stoves,
radiators, direct sunlight, etc.
• Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
• The appliance operates well in the
corresponding climate type. The
appliance may not work properly if it is
left for a longer period at a temperature
above or below the indicated range.
Important!
It is necessary to have good ventilation
around the refrigerator to allow for the
dissipation of heat, high efficiency, and
low power consumption. For this reason,
sufficiently cleared space should be
available around the refrigerator.
Leveling
The appliance should be level in order
to eliminate vibration. To make the
appliance level it should be upright and
adjusters should be in stable contact
with the floor. Also adjust the level by
unscrewing the appropriate level
adjustment in the front (use your
fingers or a suitable spanner).
32