Alarms - Minipack-Torre Mailbag Digit Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter 5. USE AND OPERATION
Display Variable
Sealing time adjustment.
Temperature adjustment
of sealing bars in
operation.
Temperature adjustment
of sealing bars in pause.
Film loosening
adjustment.
Bag lenght adjustment.
Cycle start mode
selection.
Contrast wheels closing
time after magazine
passage.
Note 1: To set all values on standard level switch the machine on keeping button (R) pressed.
Note 2: If the machine is equipped with a conveyor belt and after 10 seconds no cycles are made, the belts
automatically stops to safeguard motor lasting.

5.3 ALARMS

In case of alarms the display will show as follows:
Alarm
Meaning front door (2) (see paragraph 2.1) is open.
Motor stops in case of film jamming.
Magnets anomaly.
Wrong values are set.
Acoustic signal intervenes also when the no of pieces you have set has been reached.
The machine is fitted with "EMERGENCY" Pushbutton (S0) which, when pressed, stops and turns off
the machine instantly, stopping the work cycle.
To reset this alarm, proceed as follows:
Remove the cause of the alarm.
Release the "EMERGENCY" Pushbutton (S0) by rotating it to the right.
Value to
be set
Min. = 0,1
It adjusts the sealing time according to film quality and
Max. = 2,5
thickness.
Default = 0,8
Min. = 1 This function is useful to keep the temperature of the sealing
Max. = 10 bars always steady. The temperature of sealing bar can be
Default = 06 changed according to film thickness and quality.
Min. = 1 This function will adjusts the sealing bar temperature when
Max. = 10 the machine is not working, to keep them warm and ready for
Default = 02 use. This function is linked to the previous one.
This is an important function used especially with heavy
Min. = 0
magazines. The vertical sealing bar is starting first to block
Max. = 25
the magazine and to avoid film being too tight when the
Default = 06
transversal bar is sealing.
Min. = 0
This function will adjusts the length of the film besides the
Max. = 25
magazine.
Default = 10
It gives the possibility to select the photocell to work with
0/1/2
according to the kind of film used (0=dull film / 1=trasparent
Default = 1
film / 2=start will pedal (if available).
Min. = 0,0
Wheels closing hold next magazine on for a seal cooling
Max. = 2,5
time.
Default = 00
Cause
21
Reset
Press button (R) and close front door.
Press button (R) and place film correctly.
Press button (R) and ask for technical
support.
Press button (R) to modify them.
EN