Publicidad
Idiomas disponibles
Idiomas disponibles
The chain tension and chain lubrication have a consid-
erable influence on the service life of the saw chain.
The saw chain will be lubricated automatically while the
product is running. To lubricate the saw chain sufficient-
ly, there must always be enough saw chain oil in the oil
tank. Check the amount of oil remaining in the oil tank
at regular intervals.
Note:
• Use saw chain oil that contains additives to reduce
friction and wear or organic saw chain oil.
• For cutting trees, use organic saw chain oil. Mineral
oil can damage trees.
• Ensure that the cover of the oil tank is in place and
closed before switching on the product.
1. Place the product on a level, even surface.
2. Open the oil tank (17). To do this, unscrew the oil
tank cap (17) anti-clockwise.
3. To prevent oil from leaking, use a funnel*.
4. Adhere to the max. filling quantity of 30 ml.
5. Screw the cover of the oil tank (17) clockwise to
close the oil tank (17).
6. Wipe up any spilled oil carefully immediately and
dispose of the cloth* according to local regulations.
7. To check the product lubrication, hold the chainsaw
with the saw chain over a sheet of paper and give it
full throttle for a few seconds. You can see on the
paper whether the chain lubrication is working.
* = not included in the scope of delivery!
8.4
Inserting/removing the battery
(15) into/from the battery mount
(9) (Fig. 3)
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered
tool is ready for use.
Inserting the battery
1. Push the battery (15) into the battery mount (9). The
battery (15) clicks into place audibly.
Removing the battery
1. Press the unlock button (16) of the battery (15) and
remove it from the battery mount (9).
8.4.1
Charge level indicator on the main
switch (8) (Fig. 5)
The charge level of the battery (15) is indicated during
operation by the corresponding LED lights of the
charge level indicator on the main switch (8) lighting up.
4 LEDs illuminate
3 LEDs illuminate
1 LED illuminates
Battery fully charged
Battery partially charged
Battery must be charged
www.scheppach.com
9
Operation
ATTENTION
Always make sure the product is fully assembled
before commissioning!
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
DANGER
Danger of injury!
If the product is jammed, do not try to pull the product
out by using force.
–
Switch off the engine.
–
Use a lever arm or wedge to get the product free.
9.1
Hold and guide product
WARNING
Danger of injury due to kickback!
–
Never use the product one-handed!
WARNING
Danger of injury!
–
Never use the product without the front hand
guard!
9.1.1
Front and rear hand guards (1, 10)
(Fig. 1)
• The front hand guard (1) and the rear hand guard
(10) protect the fingers from injuries caused by con-
tact with the saw chain (11) if it breaks due to over-
loading.
• The rear hand guard (10) also protects the hand
from branches and twigs.
• Before each start-up, check the functionality of the
front handle guard (1). Keep front and rear hand
guard (1, 10) clean to ensure proper functioning.
GB | 31
Publicidad
