Heiniger TAURO Instrucciones De Manejo Originales página 27

6.2.3 Cleaning
A thin layer of lubricating oil between the upper and lower blades is essential for a good clipping
result and to increase the service life of the clipper and the clipper blade (6.2.2 Lubrication).
Clipping blades
Clean both clipping blades with a brush between uses.
7 Troubleshooting
y The here described tasks for troubleshooting can be done mostly by the operator.
y Some tasks may only be done by especially trained personal or by an authorised service
centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Machine cuts poorly
or not at all
Motor is not running
Running time of a fully
charged battery is too
short and / or blades
are getting hot
Translation of the original instructions / Hair clippers
Cause
Adjustment lever is defective
The top and bottom blades
stick to each other
Clipper blades are blunt
Clipper blades have not
been correctly ground as per
specification
Clipper blades are not oiled
Hairs jammed between top
and bottom blades
Clipper blades have too little
cutting pressure
Battery is dead
Contacts dirty
Faulty battery
Smell of burning from the
motor housing. Motor burned
out.
Faulty motor and / or electron-
ics
Clipping blade blocked
Clipper blades were not oiled
sufficiently
Rectification
Replace adjustment lever (F)
Clean and oil the blades
Have top and bottom blades resharp-
enend by service centre (S)
Oil clipper blades every 15 minutes
Remove the clipper blades, push the
upper blade halfway away from the
clipper blade, remove hair between
the upper and lower blades
Have clippers overhauled (F)
Charge battery
Switch off the clipper, clean the
charging contacts of the clipper and
power supply unit
Replace battery
Have motor and / or electronics
replaced (S)
Have motor and / or electronics
replaced (S)
Cleaning and oiling clipping blades
Oil clipper blades
13